Skip to main content
Booster KitsBrake Instruction SheetsInstruction Sheets

47-59 Chevy/GMC Truck, Power Booster Kit

By January 26, 2009January 23rd, 20134 Comments
1947-55 CHEVY TRUCK, POWER BRAKE BOOSTER KIT (ZINC) 16767
BB-T4755

NOTE: Booster may differ from picture depending on type of booster options you have chosen.

IMPORTANT: This kit is assembled for shipping
purposes only! Be sure to check all nuts and bolts for adequate torque prior to use. Don’t forget! Make sure this kit fits your application before painting or plating. Beware that chroming or painting the booster can cause it to malfunction if not performed properly. Parts that have been painted, plated or modified may not be returned.

STEPS: Read these instructions carefully before attempting this installation!

  1. Remove original master cylinder, pedal clevis and hard lines.
  2. Clean and prep the frame, as the new booster bracket mounts off of the original master cylinder mounting bracket.
  3. Remove master cylinder from power booster, as you will need to bench bleed it prior to bleeding the system. Inexpensive bleeder kits are available at any auto parts store for minimal cost.
  4. Install the booster assembly onto the original bracket that mounted the master cylinder to the frame. You will need to drill three additional holes to finish mounting the bracket assembly. A 3/8” drill bit is required and the locations of the holes are determined once the bracket is secured to the original mount.
  5. Mount the heim joint to the pedal with supplied hardware and check for proper adjustment by making sure the brake pedal is all the way  up and no pressure is being applied to the booster. Be sure to tighten the heim joint jam nut. 1947-54 Applications: Make sure the 1/2” spacer is between the pedal and heim joint. 1955-59 make sure the 3/8” thick washer is between heim joint and pedal extension
    bracket.
  6. Mount your bench bled master cylinder to the power booster. Connect all appropriate hard lines and bleed the system. Note: Disc brake applications see prop valve diagram for line port configurations. Drum brake applications use the port closest to the power booster for   plumbing the rear brakes. No proportioning valve required on drum brake applications.
  7. If you are running disc brakes be sure to have the proper proportioning valve kit for your application.
  8. Double check all of your work and proceed to check the system for any leaks.
  9. Be sure to hook up your vacuum line to the appropriate port on the manifold.
  10. On 1947-54 applications we supply a large spacer to take the place of the clutch pedal as it is very difficult to run power brakes with a
    manual transmission on these particular trucks.

Recommendations:

  1. We highly recommend that you perform a vacuum check on your particular engine. Acceptable vacuum numbers would be from 15in/hg to 22in/hg. For those who have lower numbers we offer a vacuum pump. Call for details.
  2. We also offer disc brake master cylinders and proportioning valves for those who do not want to run power brakes. Call for details.

4 Comments

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.