1973-87 Chevy C10, GMC C15 Truck Power Steering Rack and Pinion Kit

Finally, a rack and pinion power steering system for your 1973-87 Classic Chevy and GMC truck! Perfectly designed to give you the best steering you can have and provide much higher performance and driver comfort. On this kit we used a traditional style rear steer rack & pinion that is mounted to a one piece bracket which bolts up to the outside of either frame rail in the same holes as the original steering box and idler arms. This kit is for rear wheel drive vehicles only, NOT 4x4s. Installs have been done on V-8s, so there should be room if using a 6 Cylinder. There is quite a bit of room for the shaft support, but some headers may require modification. A two groove pulley  on your water pump is required for this kit.

Application info:

• This kit is designed with correct Ackermann and reduced bump steer.
• Has increased exhaust clearance over a stock box.
• Works with any height springs.
• Works with stock or aftermarket steering column.
• Works with disc brakes

Kit includes:

• Power Rack and Pinion (2-7/8 turns lock to lock)
• 3/4"DD input shaft
• Rack & Pinion Mount Kit
• Collapsable steering shaft kit
• Pump & Hose Kit (-6an Fittings)
• Inner Tie rod ends (uses factory outer tie rod ends)
• Hardware
• Complete installation guide
• Limited lifetime warranty

Fits: 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982 1983 1984 1985 1986 1987 Chevy C10, GMC C15 truck Suburban and 2wd Blazer